Kubota B3200 Tractor Workshop Service Manual
Kubota B3200 Tractor Workshop Service Manual
Publication: 9Y111-02060
Format: PDF
Kubota B3200 Tractor Workshop Manual
Kubota B3200 Tractor Workshop Service Manual
Kubota Tractor Model B3200
Publication: 9Y111-02060
Format: PDF
Table of Content of the Workshop Service Manual
This Workshop Manual has been prepared to provide servicing personnel with information on the mechanism, service and maintenance of B3200. It is divided into three parts, General, Mechanism and Servicing.
General
Information on the tractor identification, the general precautions, maintenance check list, check and maintenance and special tools are described.
Mechanism
Information on the construction and function are included. This part should be understood before proceeding with troubleshooting, disassembling and servicing.
Refer to Diesel Engine / Tractor Mechanism Workshop Manual (Code No. 9Y02101876 / 9Y021-18201) for the one which has not been described to this workshop manual.
Servicing
Information on the troubleshooting, servicing specification lists, tightening torque, checking and adjusting, disassembling and assembling, and servicing which cover procedures, precautions, factory specifications and allowable limits.
All information illustrations and specifications contained in this manual are based on the latest product information available at the time of publication.
The right is reserved to make changes in all information at any time without notice.
Due to covering many models of this manual, information or picture being used, have not been specified as one model.
IMPORTANT INSPECTION ITEMS AFTER REASSEMBLING
a Operate the Kubota B3200 Tractor and check for Unusual Noise and Vibrations.
b Make Sure the Safety decals and Wire harness Clamps are in their Specified Positions.
c With the Machine Front in a Specified Posture, Check the Amount of Hydrauric Oil Checking the oil level (For further details, refer to the Tractor B3200 Operators Manual)
1) Park the machine on a level ground.
2) Make sure the hydraulic oil temperature is in the range of 10-30C (50-86F) and see if the oil level is within the specified zone of the oil level gauge.
3) Keep the machine front as shown as following posture.