-modified.png&width=65&height=65&quality=80&format=auto&fit=crop){kind=logo}
Handheld 4" Display Tiny Spectrum Analyzer TinySA ULTRA 100kHz to 5.3GHz with 32GB Card Version V0.4.5.1
Shipping Type:
Quantity
Official version, supports the latest firmware, cooperates with Zeenko
Features:
- Screen size 4 inch
- Spectrum Analyzer for 0.1-800MHz or, with Ultra mode enabled, 0.1MHz-6GHz
- Signal Generator with sine wave output between 0.1-800MHz or dual tone output up to 4.4GHz when not used as Spectrum Analyzer.
- Switchable resolution bandpass filters for both ranges between 200Hz and 850kHz
- Built-in 20dB optional LNA
- Color display showing 450 scan points covering up to the full frequency range.
- Input Step attenuator from 0dB to 31dB (not in combination with LNA).
- A built-in calibration signal generator that is used for automatic self test and (low) input calibration.
- Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer or Signal Generator
- Rechargeable battery allowing a minimum of at least 2 hours portable use
- Max input level +10dBm. Do not destroy your tinySA
- Due to the low cost and very small form factor there are certain relevant tinySA limitations and tinySA Ultra limitations
Specification
Parameter | Specification |
Display size | 4” TFT LCD (480×320) |
Max low input frequency | 800MHz, 6GHz in Ultra mode |
Resolution filters in 1,3,10 steps | from 200Hz to 850kHz |
Max output frequency | Sinus up to 800MHz |
output level | -104dBm to -16dBm |
Ultra mode | Level calibrated up to 5.3GHz |
Internal LNA gain | 20dB up to 4GHz |
Displayed points per scan | max 450 |
0-350MHz scan time | 165ms |
Shortest zero span time | 17ms |
DANL at 100MHz | -153dBm/Hz (LNA Off) / -169dBm/Hz (LNA On) |
DANL degrading in ultra mode | 10dB above 2.5GHz, 25dB above 5.3GHz |
Phase noise at 10kHz bias | -92dBc/Hz |
Phase noise at 100kHz bias | -110dBc/Hz |
Input 1dB compression level | +0.5dBm (LNA Off) / -26.5dBm (LNA On) |
IIP3 without LNA | +18dBm (at least 2MHz apart) / 0dBm (500Hz apart) |
IIP3 with LNA | -8dBm (at least 2MHz apart) |
Frequency stability | <1ppm ( -10℃ ~ +55℃) |
SD card slot | micro SD card |
Audio out | 3.5mm headphone plug |
FW update mode activation | Push jog button before switch on |
Maximum current consumption | 330mA |
Maximum charging current | 1300mA |
Battery | Li-polymer 3.7V 3000mAh |
RF connectors | SMA female |
Communication Interface | USB-CDC(Type-C)UART-TTL(2.54mm Connector) |
Appearance Size | 117x72x23mm (Excluding protruding parts) |
Package includes:
1 x Host
1 x USB Type-C data cable
2 x 30cm ALSR100 SMA cables
1 x SMA-SMA barrel connector
1 x Antenna with SMA connector
1 x Lanyard and touch plectrum
1 x 32GB MicroSD card(plugged in the host)