Ahri tail KDA Baddest cosplay pattern

I offer you a pattern of the tail of kDa AHRI, in the format: 
- PDF, for printing (height 80cm, width 21.6 cm, depth 72.5 cm) 
- PDO in order to open the program pepakura and adjust the desired size
Recommended materials:
- PET plastic with a thickness of 0.3 mm (the thicker the plastic, the heavier and stronger the tail
- Car membrane for tinting headlights with the chameleon effect, to get a flickering effect.

What tools will be required?
Sharp office knife
 hot air hair dryer and soft spatula (for sticking membrane) 
Soldering iron ( PET plastic is soldered together)

Lines that are marked with a dotted line - fold lines, they need to be cut with a knife in half (not through). A dotted line is a convex angle, and a dotted line with a dot is a concave angle.

If desired, the tail can be pasted with a colored film and put inside the backlight.