Crown machine embroidery design
Crown machine embroidery design 214
This design comes with 13 sizes:
6.08” x 7.01” (154.4mm x 178.0mm) 23765st
5.64” x 6.50” (143.2mm x 165.2mm) 20611st
5.20” x 6.01” (132.2mm x 152.6mm) 17762st
4.77” x 5.50” (121.2mm x 139.8mm) 15090st
4.34” x 5.01” (110.2mm x 127.2mm) 12586st
3.91” x 4.50” (99.2mm x 114.4mm) 10402st
3.47” x 4.01” (88.2mm x 101.8mm) 8349st
3.04” x 3.50” (77.1mm x 89.0mm) 6532st
2.60” x 3.01” (66.0mm x 76.4mm) 4967st
2.17” x 2.50” (55.0mm x 63.6mm) 3609st
1.73” x 2.01” (44.0mm x 51.0mm) 2502st
1.30” x 1.50” (33.0mm x 38.2mm) 1550st
0.86” x 1.00” (21.8mm x 25.4mm) 830st
The following 10 formats are included in the file you will receive:
* DST - (Tajima)
* EXP - (Melco)
* HUS - (Husqvarna,Viking)
* JEF - (Janome,Elna,Kenmore)
* PES - (Brother,Deco,Babylock)
* SEW - (Janome,Elna,Kenmore)
* VP3 - (Husqvarna,Viking)
* VIP
Please note this is NOT a patch or a physical item. This is an embroidery design. You will need an embroidery machine to stitch these designs out.
**********************************************************************
You MUST have an embroidery machine and the software needed to transfer it from your computer to the machine to use this file. This listing is for the machine file only - not a finished it.
***********************************************************************
For a quality stitched design, I recommend using proper stabilizer and needle size for the project fabric along with quality thread. In particular, with fine gauge and knit fabric, such as T-shirts and baby onsies, I find it best to use a sticky back stabilizer on the fabric with a stitch and tear stabilizer on top of it inside the fabric AND a wash away stabilizer on the outside of the fabric, especially when stitching fonts or thin lines. A thinner gauge knit needle can prevent needle holes as well.
